Sleek wall mount for Skådis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an alternative for the original Skådis wall mount nubs/screws. It also has a snap-on cover to hide the screw.
- Rating
- 5 / 5
- Likes
- 93
- Downloads
- 397
- Makes
- 9
- Views
- 2,330
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a modern and sleek alternative to mounting your IKEA Skådis. (and Uppspel)
In comparison to the original nubs/screws that came included, these mounts with a countersunk M4 screw in the center of the Skådis holes. Then they can be covered up with a cap that snaps into place and hides the screw. Resulting in a sleek and minimalistic look.
It also has all of the necessary cutouts to make it compatible with the included spacers/braces. Tolerances are generally between 0,15 mm and 0,30 mm depending on the part.
Nozzle:
- 0,4 mm no need for a smaller one!
Layer height:
- 0,2 mm for the mount is generally good enough. (if not, go smaller)
- 0,1 mm for the cap/cover for the best finish and “snap”.
At least 3 perimeter and 100% infill is also recommended.
*Note: Depending on material and other factors the cover clips might break, if you remove it from the mount. In addition the cover can be hard but not impossible to remove.