Ultimaker 2/2+ BLTouch Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This allows you to mount a BLTouch to the Ultimaker 2/2+ Printhead.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 138
- Makes
- 0
- Views
- 1,411
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This model replaces the bottom plastic section of an Ultimaker 2/2+ Printhead.
It also features routing holes on the sides for easy side fan wire routing and a channel behind the BLTouch mounting point to safely route the BLTouch cables.
Special Notes:
As long as your screws do not stick out the top of the BLTouch mounting location, it should slide cleanly under your front drive belts without issues.
If you find the Z offset is too far, use washers between the BLTouch and the mount to lower the position of the BLTouch
Printing Instructions:
Support will be needed.
Print in PETG / Nylon / ABS
You could optionally print this in resin.