Ultimaker 2/2+ BLTouch Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This allows you to mount a BLTouch to the Ultimaker 2/2+ Printhead.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 138
- Wydruki
- 0
- Wyświetlenia
- 1411
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This model replaces the bottom plastic section of an Ultimaker 2/2+ Printhead.
It also features routing holes on the sides for easy side fan wire routing and a channel behind the BLTouch mounting point to safely route the BLTouch cables.
Special Notes:
As long as your screws do not stick out the top of the BLTouch mounting location, it should slide cleanly under your front drive belts without issues.
If you find the Z offset is too far, use washers between the BLTouch and the mount to lower the position of the BLTouch
Printing Instructions:
Support will be needed.
Print in PETG / Nylon / ABS
You could optionally print this in resin.