Elephants Foot Test Print
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fast, low cost print I use to dial out any elephants foot on my models by changing my z offset.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 121
- Makes
- 1
- Views
- 421
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Public Domain
Measure flat side to flat side on the bottom and the top of the model using callipers, they should both be 20mm. Elephants foot will make the bottom bigger. Its important to measure the very bottom of the model as elephants foot only effects first few layers.
The print also has a hole in the middle that can be used to join two test prints together as shown, There is .2mm of clearance between so they should fit together loosely if printer is tuned well.
I've added a smaller but faster print time version that functions the same!