Hampton Bay Fan Remote Wall Holder/Mount
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.40 – €2.93 net (excluding VAT)
For file: fan remote v13.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.66 excluding VAT (range midpoint).
- Weight reported by the author
- 20 g
- Print time reported by the author
- 3.3 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
My Hampton Bay Mena 54 inch fan from Home Depot didn't come with a wall-mount for the fan remote, so I designed this.
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 209
- Makes
- 4
- Views
- 768
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
My Hampton Bay Mena 54 inch fan from Home Depot didn't come with a wall-mount for the fan remote, so I designed this.
It has a flat back because I use 3M sticky stuff to mount it.
https://www.amazon.com/gp/product/B000BL2REK/
You could easily drop this into Tinkercad if you wanted to make a screw hole in it.
Orient vertically for printing.
I print at .2mm layer height with 50% cubic infill in PLA+ with no supports. I print with a brim but it's probably not necessary if you get good adhesion. Took 3 hours and 17 minutes at these settings on my Creality Ender 3 and used 20 grams of filament. You could probably print at a finer layer height if you want smaller layer lines and don't mind a longer print time.