Slow Cooker Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Migrating from thingiverse
https://www.thingiverse.com/thing:3831884
Handle for a generic small slow cooker.
the one that came with it broke into pieces. more like crumbled into pieces.
slow cooker has a diameter of 21.5cm
mounting holes are 4cm apart.
highly recommend to use ABS since it will probably get hot.
but since i don't have an enclosure, the ABS print was unusable, was too brittle. (brown version in the pictures). ended up printing one in Red PETG, until i can build an enclosure for my CR-10S Pro.
04/09/2019
well PETG melted.... ir temp says that the cooker was getting up to 150°C ...
reprinted in ABS, and line the part that makes contact to the cooker with a small layer of silicon to act as a heat-break . working so far....
FreeCad File included
highly recommend to use ABS since it will probably get hot.
make sure to use more Wall Line for strength, i used around 6 - 9