Filament Runout Sensor Bracket for Sovol SV04
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The bracket moves the filament run out sensor, down 20mm, forward 20mm, and tilts it towards the filament roll.
- Rating
- 4.889 / 5
- Likes
- 51
- Downloads
- 424
- Makes
- 10
- Views
- 1,806
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
The bracket moves the filament run out sensor, down 20mm, forward 20mm, and tilts it towards the filament roll.
This reducing the friction the filament runout sensor adds because the original orientation has the filament enter at too much of an angle. The new location will not reduce the avaible Z printing area.
No additional hardware needed. Uses the original screws and bolts, and slides into the 20x20 extrusion.
This model is for the left filament runout sensor, mirror it in your slicer for the right side.