3" Sanding Pad / Sanding Disk Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a set of holders for 3" / 75mm Velcro backed sanding pads. I have previously made a set of holders for 5"…
- Rating
- 0 / 5
- Likes
- 34
- Downloads
- 158
- Makes
- 0
- Views
- 854
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
EDIT 12FEB24: I am not sure when it happened, but all except 4 of the models were corrupted / deleted. I just re-uploaded them all today, so hopefully that won't happen again.
– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – –
This is a set of holders for 3" / 75mm Velcro backed sanding pads.
I have previously made a set of holders for 5" disks here and from requests, made them for a bunch of grits. I used that info to make these with all of the requested grits right off the bat, so these are available in the following grit labels:
40, 60, 80, 100, 120, 150, 180, 220, 240, 320, 400, 600, 800, 1.0K, 1.2K, 1.5K, 2.0K, 3.0K, and blank.
This set has "3 Inch" on the holder. If you want "75mm" on the holder, they are located here.
I made them with the corners open on the bottom so I could weight them with sand or lead shot and epoxy, then put some neoprene on the bottom to prevent them from moving around on my bench. I just printed one to try it out, and it looks good, but I may be slightly biased. :-)
Print Settings
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
20%
Filament: Hatchbox / AMZ3D PLA Red
Category: Tool Holders & Boxes