Camping chair feet for 13mm leg (decathlon MH500 )
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
a replacement feet for camping chairs
- Rating
- 4.5 / 5
- Likes
- 43
- Downloads
- 311
- Makes
- 5
- Views
- 2,240
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
lost two feet of my chair in a trip, was already sinking into wet ground a bit before, found the original file and made the inner diameter smaller then removed the holes
2024/10/8 update: revisiting the file because I need to print a set for a friend, optimized such that it can be printed without support, Brim is recommended for stability, the tolerance for the center hole is a bit tighter now as machines are improved between now and the creation of the original file
printed with PETG, 30% gyroid 4 wall and 8 bottom/top layer, held up to a trip on gravel ground and a night on ceramic floor, should be safe to use
other filament should work as well, PLA is not recommended