Pipe/cylinder outside chamfer tool
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.24 – €1.52 net (excluding VAT)
For file: chamferCubeV3_0.1mm_PLA_MK3S_1h49m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.38 excluding VAT (range midpoint).
- Weight reported by the author
- 8 g
- Print time reported by the author
- 1.82 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A tool to chamfer the outside edge of a cylinder or pipe after cutting with different angles.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 0
- Views
- 735
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
After sawing some aluminium rods and pipes to length I always end up with a bad cut and rough edges. The inside edges of pipes are easily cleaned up with a deburring tool but the outside edge is more tricky (if you don't have a belt or disk sander to rotate the piece against. So i came up with this tool to remove the burrs and give the piece the desired chamfer angle.
Assembly:
- Scale model before printing to fit your requirements.
- Either use self-adhesive sandpaper or use double sided tape to make some and cut it into strips from which you cut some wedges, as shown here:
- Then place as many of the wedges as you want or will fit into the cone shaped holes on the cube, like this:
ToDos:
It works but after using it there are still a few more improvements I'd like to make
- Add a guide for keeping the tool coaxial
- Try other methods of attaching the sandpaper
- Maybe swap the sandpaper for a file