CTC E3d Chimera/Cyclops hotend mount - bowden
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my way to mount e3d Chimera hotend to original CTC (Replicator 1 clone) XY carriage. This design allows you to…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 385
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is my way to mount e3d Chimera hotend to original CTC (Replicator 1 clone) XY carriage. This design allows you to easy assemble/disassemble hotend in case of any issues or maintenance. From hardware, you will need some M3 screws to connect printed parts and 2-3 washers to adjust the distance to X endstop.
I am using older version of the desig and it works well for the last month. In near future I am planning to add special fan duct to this (the first sketch is included in rsdoc file).
In my setup I used china clone of e3d Chimera hotend. And becaude of this I had to drill thru bowder tube holder to put bowden tube inside chimera block without this it was almost unprintable.
Print Settings
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 1
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
100
Notes:
I printed it with PLA with 0,2 mm layer height and works well. Support needed only for RightLeg.
Category: 3D Printer Parts