1 / 3
Conduit Panel for Eurorack (1U_30HP)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A panel with a built in conduit space to run patch cables through for cable management
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 23
- Makes
- 0
- Views
- 355
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial
- Allows patch cables to be run out of the way as a cable management solution.
- Made specifically for an Intellijel case with a 1U row (I should think it will fit any case with a 1U row though)
- Can run roughly 6 patch cables comfortably through the plate. Any more than that and you may get them stuck inserting or removing from the plate.
- Larger sleeved cables may not fit. (Moog patch cables confirmed not to fit)
----------------------------------------
Print Settings:
- Material: PLA
- Layer Heigh: .20mm
- Infill % 5%
- Supports: Support on build plate only.
NOTE: Set Bridging angle to 90 degrees. (Or 90 degrees relative to the top of the plate. This allows the bridging for the conduit part to have a short run across open air instead of a long run at an angle.)