Dramatic USB Button
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D-printed USB button, which can be programmed to do anything you like - With style.
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 36
- Makes
- 0
- Views
- 693
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- GNU General Public License v3.0
Hi everyone!
This is a 3D-printed USB button I created a while back.
As many people asked for the files, I have decided to upload it here.
If you like this project, follow me on Instagram (@do.robotics).
What do you need
- 1 x ATtiny85 development board
- 1 x Resistor (I'm using a 390ohm)
- 1 x SPST momentary push button (normally open)
- 1 x USB Extension Cable (desired length)
- 1 x 3mm screw - used to hold the female USB connector in place.
- Soldering kit
- Jumper wires
Assembly
This should be straight forward with the provided images.
Some tips:
- Save some space by soldering the resistor directly to one leg of the resistor.
- Solder the 3 ATtiny pins facing up, as can be seen in the picture.
- Make sure to heat-shrink/wrap everywhere, to avoid shorts.
Code
https://github.com/dordchn/usb-button
Important note
This may be obvious, but I still want to clarify that building and using the button is at your own risk. However, I can testify that I built mine a few months back and It works perfect so far :)