Longshot Bolt Handle replacement-uses original bar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement part for a old Nerf blaster toy. The original bolt handle came off due to the insides breaking (should…
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 60
- Makes
- 0
- Views
- 330
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
Replacement part for a old Nerf blaster toy. The original bolt handle came off due to the insides breaking (should look like this but the part that contacts the metal was broken off entirely). I wanted to replace the just broken part.
I think the Longstrike bolt is the same, though I am unsure, so I guess it might work on that as well.
I'd advise you to print this in a brightly coloured plastic.
Fit should be pretty snug and secure, if you print Bolt test fit.stl you'll find out whether or not you need to scale up. I measure the metal part it attaches to to be about 4.6mm so I made the hole 4.8mm, which seems good. A tiny piece of thin tape wrapped around the metal part also improves fit, very well. Print X and Y at 101-103% scale if it's too tight.
File info
Longshot bolt handle.stl The replacement bolt handle itself. Bolt test fit.stl A file to test the fit on yours. Longshot bolt handle smooth.stl A replacement bolt handle but smooth if needed.
Print Settings
Supports:
No
Resolution:
0.2mm
Infill:
30%
Filament:
eSun PLA+
Fire Engine Red
Category: Sport & Outdoors