Longshot Bolt Handle replacement-uses original bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement part for a old Nerf blaster toy. The original bolt handle came off due to the insides breaking (should…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 328
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Replacement part for a old Nerf blaster toy. The original bolt handle came off due to the insides breaking (should look like this but the part that contacts the metal was broken off entirely). I wanted to replace the just broken part.
I think the Longstrike bolt is the same, though I am unsure, so I guess it might work on that as well.
I'd advise you to print this in a brightly coloured plastic.
Fit should be pretty snug and secure, if you print Bolt test fit.stl you'll find out whether or not you need to scale up. I measure the metal part it attaches to to be about 4.6mm so I made the hole 4.8mm, which seems good. A tiny piece of thin tape wrapped around the metal part also improves fit, very well. Print X and Y at 101-103% scale if it's too tight.
File info
Longshot bolt handle.stl The replacement bolt handle itself. Bolt test fit.stl A file to test the fit on yours. Longshot bolt handle smooth.stl A replacement bolt handle but smooth if needed.
Print Settings
Supports:
No
Resolution:
0.2mm
Infill:
30%
Filament:
eSun PLA+
Fire Engine Red
Category: Sport & Outdoors