Lithophane Lamp with Lighted Backsplash V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed to make a new one for a gift & I didn't like a few aspects of the old one so I remade it.
- Rating
- 0 / 5
- Likes
- 72
- Downloads
- 264
- Makes
- 1
- Views
- 1,681
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The new version is slightly more slim, doesn't throw beams of light to the sides, & the design file is a lot tidier.
To generate a lithopane that fits go to https://lithophanemaker.com/Curved%20Lithophane.html and use the following settings:
- Height: 125
- Angle: 90
- Maximum Thickness: 3.2
- &Make sure you upload a 4:3 aspect ratio landscape photo
Settings not mentioned above shouldn't matter much for fitment.
I've included a lithophane blank for checking that your generated lithophane is the correct size.
Supplies Needed:
- 1x of every STL here, printed (except for the lithophane size exmple)
- 1x printed lithopane that fits
For the light hardware, you can get creative. The following is just what I used:
- 1x 0.5in section of 1/8-IP threaded nipple
- 1x Tapped 1/8-IP Hex Nut
- 1x E11 Socket /w a receiver for the 0.5in 1/8-IP nipple on the bottom (fairly standard lamp hardware)
- 1x 50-Watt Equivalent Bright White (3000K) T4 Mini Candelabra E11 Base Decorative LED Light Bulb (or any bulb that fits)
- 1x 8ft power cord
- 1x feed-through on/off switch
I've also included the STEP file in case anyone wants to further modify this lamp