EXIT trampoline - Net support pole end cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
EXIT trampoline end caps
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 48
- Makes
- 0
- Views
- 429
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement end cap to go on the top of the vertical poles, supporting the top ring which holds the safety net.
Many of my original brackets snapped off after a few years so I designed this replacement as EXIT will not sell you the caps alone. See photos 4 and 5 for the failure of the original parts.
It must be printed lying on it's side so that you have maximum lateral strength. I would strongly recommend to also align the upper slot vertically so no support is needed there.
See the last photo for best orientation.
The support is a bit of a pain to get out but it is worth it to avoid the inner spike shearing off along the layer lines.
Even though it is outdoors, I print these in PLA. After a whole summer in 40C weather, there is no sign at all of degradation. This is due to them being very thick walled. You could print them in ASA etc but I have found PLA is just fine.
I designed it in TinkerCAD