Desk Organizer Spring Loaded
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Here is a desk organizer that uses a constant force spring to maintain a tidy appearance.
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 20
- Makes
- 0
- Views
- 388
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Here is a spring loaded desk organizer.
You will need the following components:
Constant Force Spring (QTY. 1)
M3 x 8 Countersunk Head Screw (QTY. 2)
25mm LG. 3mm Rod (QTY. 1)
#8 Wood Screw (QTY.1)
Assembly Notes:
The wood screw is used to bolt the organizer to the side of a wood table.
Assembly should be pretty straightforward. I included an assembly step file in case you are confused.
One of the M3 screws is used to hold the end of the constant force spring, and the other is used to secure the back plate to the base.
The constant force spring is a little tricky to get onto the axle but I just extended it completely and got it on without too much hassle.
The screw hole for the M3 screw on the slider is printed with a skin to support the hole, so you will need to go at it with a knife to break through the skin.
I printed everything out of PETG at 0.3mm layer heights but I'm sure finer layer heights would work fine.
Happy printing!