1 / 4
Original Prusa Enclosure Filament Passthrough
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed to feed filament from my 3kg spool, so i have designed the passthrough port for the enclosure.
- Rating
- 5 / 5
- Likes
- 67
- Downloads
- 346
- Makes
- 6
- Views
- 2,209
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The bowden fitting is very firm, you might need to use players to push it in. If your print tolerances are a bit off. Use a 4mm drill to remove the excess from the print walls for the bowden fitting.
- Print it flat with no support.
- Reuse the nylon rivets.
- You will need about 45 - 50 cm long bowden tube.
- print it as 0.15mm layer height it will take about 20 minutes.
I have printed this in PLA however any other material can be used.