Thermocouple Strain Relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Reinforcement for standard kitchen thermocouple
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 22
- Makes
- 0
- Views
- 219
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
I designed this after continuously repairing the cable after the fragile cables would break from normal use. It may be a bit overkill but it should support the cable enough to prevent the smaller internal wires from breaking.
This connector uses 4 M3x8 screws and 4 M3 nuts to hold the two halves together. The spacing for the nuts is a little tight so a soldering iron might be needed to heat them and press them in place. Another method (what I did) would be to heat the nozzle of your printer and lower the Z axis and nozzle on top of the nut. This will heat the nut up and press it into the part.
Happy printing and I hope this helps!