Water Spigot - Spinning Non Functional Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kids in the Neighborhood left my Water Spigot/Faucet on outside without me knowing. Designed a handle that just spins.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 11
- Makes
- 0
- Views
- 266
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
I didn't want the kids turning on my water outside anymore. I started with removing the handle. But decided I would have a little fun and design a handle that would just spin if they tried to use it.
This only required me to print 2 pieces. I designed an end cap that would fit the Water Spigot that was also a round shaft to support the spinning handle(the second piece).
I first installed the Spinning Handle and then installed the end cap then fastened the end cap to the Water Spigot with the existing screw.
NOTE: I measured the square shaft for my Water Spigot. It is about 7mm x 7mm. So if your water Spigot is a different size it may not work.
Printed in PETG
20% infill
Used 0.6mm nozzle
Layer Height .2mm
There should be enough tolerances for the part to spin freely on most print settings. It has a gap of 1mm.