Water Spigot - Spinning Non Functional Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kids in the Neighborhood left my Water Spigot/Faucet on outside without me knowing. Designed a handle that just spins.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
I didn't want the kids turning on my water outside anymore. I started with removing the handle. But decided I would have a little fun and design a handle that would just spin if they tried to use it.
This only required me to print 2 pieces. I designed an end cap that would fit the Water Spigot that was also a round shaft to support the spinning handle(the second piece).
I first installed the Spinning Handle and then installed the end cap then fastened the end cap to the Water Spigot with the existing screw.
NOTE: I measured the square shaft for my Water Spigot. It is about 7mm x 7mm. So if your water Spigot is a different size it may not work.
Printed in PETG
20% infill
Used 0.6mm nozzle
Layer Height .2mm
There should be enough tolerances for the part to spin freely on most print settings. It has a gap of 1mm.