1 / 5
3M Adflo Adapter for 3M Bayonet Filters — image 1
1 / 5

3M Adflo Adapter for 3M Bayonet Filters

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapter to allow 3M bayonet filters to be used with 3M Adflo blower.

Rating
0 / 5
Likes
31
Downloads
351
Makes
0
Views
2,605
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

DISCLAMER: You are solely responsible for your health and safety by choosing to use this non-approved adapter.  

Adapter to allow 3M bayonet filters to be used with 3M Adflo blower. Replaces the stock filter and filter cover and secures with screws from the inside of the blower. Print with extra perimeters and top and bottom layers to make it as air tight as possible.

 

Required Hardware:

 

Assembly:

  1. Cut 2mm of the bottom of the inner section of the filter connector and rough up exterior with knife or low grit sandpaper.
  2. Glue filter connector to hole on the print with plastic bonding epoxy.
  3. Cut 5mm foam to make seal for the blower fan inlet and secure to the rear of the print.
  4. Disassemble blower and secure the adapter to the blower housing with a clamp or tape.
  5. Drill 2.8mm holes through blower housing and into adapter between the reinforcement ribs of the housing.
  6. Thread low profile M3 screws through the drilled holes, screws will cut their own threads.
  7. Secure with 6-10 Screws.
  8. Reassemble blower unit.

 

Tags