1 / 5
3M Adflo Adapter for 3M Bayonet Filters
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to allow 3M bayonet filters to be used with 3M Adflo blower.
- Ocena
- 0 / 5
- Polubienia
- 31
- Pobrania
- 351
- Wydruki
- 0
- Wyświetlenia
- 2605
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (30)Powiązane
DISCLAMER: You are solely responsible for your health and safety by choosing to use this non-approved adapter.
Adapter to allow 3M bayonet filters to be used with 3M Adflo blower. Replaces the stock filter and filter cover and secures with screws from the inside of the blower. Print with extra perimeters and top and bottom layers to make it as air tight as possible.
Required Hardware:
Assembly:
- Cut 2mm of the bottom of the inner section of the filter connector and rough up exterior with knife or low grit sandpaper.
- Glue filter connector to hole on the print with plastic bonding epoxy.
- Cut 5mm foam to make seal for the blower fan inlet and secure to the rear of the print.
- Disassemble blower and secure the adapter to the blower housing with a clamp or tape.
- Drill 2.8mm holes through blower housing and into adapter between the reinforcement ribs of the housing.
- Thread low profile M3 screws through the drilled holes, screws will cut their own threads.
- Secure with 6-10 Screws.
- Reassemble blower unit.