quick and dirty remix for MH-Z19 CO2 sensor and qtpy snap case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
quick and dirty remix for MH-Z19 and SCD4x CO2 sensors and qtpy snap case. printed at high speed in eSUN PLA-LW 40% flow
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 1
- Views
- 474
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
really bad quick and dirty remix for MH-Z19 CO2 sensor and qtpy snap case.
9mm squares plus MH-Z19 cut out of top and tall-frame, roughly centered to allow for either pin end used
Printed at high speed in eSUN PLA-LW (235c 40% flow) which is now my favourite for prototyping as it prints like foam-board and is cuttable at this density ($33/kg makes it price equivalent taking 40% into consideration).
-Edit- Provided version for Cabled MH-Z19, which is offset by 4mm from the centered version
-Edit- Added shelf using Gravity Sketch, playing with SUBD modelling. After test fit there is space for an adhesive pad beneath the sensor, bringing it closer to the lid and securing it fully.
Model of MH-Z19 from grabcad by https://grabcad.com/thmjpr
https://grabcad.com/library/mh-z19-module-1