1 / 2
Low Voltage Switch Enclosure
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for a low voltage (direct current) switch.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 11
- Makes
- 0
- Views
- 181
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an enclosure for a small direct current light switch that I installed in a shed. It is used to control ceiling lights off a battery.
It prints fast (without supports) and needs a bit of hardware:
- 2 x M2.5 8mm screws
- 2 x M2.5 threaded inserts
- 2 x PG7 cable glands (example reference)
- 1 x JR 12635 switch (exact reference)
- 2 x wood screws (to attach the enclosure to a stud or similar)
Because the shed is uninsulated and is also partially a greenhouse, I used PETG instead of PLA but PLA would be adequate in environment where high temperature is not a concern.