mini Satsana Dual 4010 Remix for Ender 3 v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a remix of the mSatsana fan duct and hotend cover for the Ender 3 v2 that uses dual 4010 fans and threaded inserts.
- Rating
- 3.667 / 5
- Likes
- 72
- Downloads
- 543
- Makes
- 2
- Views
- 4,249
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
V1.1 Update: Redid some of the geometry at the front, modified the back for better and more enclosed hotend and cooling air separation and for better cable routing.
It's a remix of the miniSatsana fan duct and hot-end cover for the Ender 3 v2 that uses dual 4010 fans and threaded inserts, compatible with the mounting bracket included with the CR Touch bed leveling sensor.
It's divided into 3 parts for easier printing, and you can even use PLA, the constant airflow will keep it from warping too much.
It uses M3*4 or 5mm deep 5mm wide heated inserts for the hotend cooling fan, and M2*3mm deep and 3.5mm wide for the part cooling 4010s. For screws youre going to need M3*12/25mm (depending on if your hotend fan is 10 or 20mm thick) and M2*8mm for the 4010 part cooling fans.
The two inserts on the back should be M2*4mm deep and 3.5mm wide with M2*6mm screws.
Print settings.
Print settings for CURA: Smart Hiding of the seam, tree supports, 70 degrees overhang angle touching the buildplate worked very well.