1 / 4
mini Satsana Dual 4010 Remix for Ender 3 v2 — zdjęcie 1
1 / 4

mini Satsana Dual 4010 Remix for Ender 3 v2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

It's a remix of the mSatsana fan duct and hotend cover for the Ender 3 v2 that uses dual 4010 fans and threaded inserts.

Ocena
3,667 / 5
Polubienia
72
Pobrania
542
Wydruki
2
Wyświetlenia
4220
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

V1.1 Update: Redid some of the geometry at the front, modified the back for better and more enclosed hotend and cooling air separation and for better cable routing.

It's a remix of the miniSatsana fan duct and hot-end cover for the Ender 3 v2 that uses dual 4010 fans and threaded inserts, compatible with the mounting bracket included with the CR Touch bed leveling sensor.

It's divided into 3 parts for easier printing, and you can even use PLA, the constant airflow will keep it from warping too much.

It uses M3*4 or 5mm deep 5mm wide heated inserts for the hotend cooling fan, and M2*3mm deep and 3.5mm wide for the part cooling 4010s. For screws youre going to need M3*12/25mm (depending on if your hotend fan is 10 or 20mm thick) and M2*8mm for the 4010 part cooling fans. 

The two inserts on the back should be M2*4mm deep and 3.5mm wide with M2*6mm screws.

Print settings.

Print settings for CURA: Smart Hiding of the seam, tree supports, 70 degrees overhang angle touching the buildplate worked very well.

Tagi