Ranger's Apprentice Throwing Knife or Knives
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.50 – €0.61 net (excluding VAT)
For file: Throwing Knife Handle.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.56 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 45 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
When out of range for hand to hand combat, the throwing knife may be the weapon of choice.
- Rating
- 5 / 5
- Likes
- 101
- Downloads
- 459
- Makes
- 2
- Views
- 2,026
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution
This was inspired by the Ranger's Apprentice stories by John Flanagan and the fan discussion here (https://flanagan.fandom.com/wiki/Flanagan_Wiki). I wanted to keep it simple and safe for those younger apprentices.
The throwing knife has a heavy grip made with a series of leather discs one above the other with a matching brass pommel and hilt. The blade is narrow at the hilt and tapers sharply outwards becoming thicker and wider for ¾ of the length. Then, there is a steep reverse taper to a sharp point. I have seen where the blade should be 20 cm but that seemed to make the knife quite large and unwieldly so I made it more ninja sized. It seems to fit better with the Double Scabbard.
This model comes in 2 parts - the handle with pommel and the blade with hilt. Printing vertically allows for a color change. The pommel and hilt are printed down on the table. There is a notch at the top of the handle that can be glued into the hilt. I printed at 0.2 mm detail with no supports. I was able to print both pieces without a brim. Depending on your printer you may need to add a 10-20 mm brim.
The scabbard is in a separate model.