1 / 2
Printed TPU Feet for Voron 2.4
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printable feet for Voron 2.4 / 2.4r1
- Rating
- 5 / 5
- Likes
- 69
- Downloads
- 361
- Makes
- 3
- Views
- 3,467
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
Printed TPU Feet for Voron 2.4 / 2.4r1
This is not compatible with V2.4r2
I'm not a fan of the looking of compressor rubber feet, but still too lazy to switch the Z drives and skirts to V2.4r2. So I made these printed feet with a low-poly Stealthburner-ish look.
- You can print the foot in TPU, or print the bottom 4mm with ABS and do a filament swap so the M5 screw is pressed against hard material.
- The base_plate is optional. But the foot can rotate on flat surface so the base_plate has a cut-out to lock the TPU foot.
- The TPU foot will hold the m3 screws from falling out but keep the hex holes accessible so you can take the base_plate off without removing the TPU foot.
- I printed with TPU 95A at 4 perimeters 30% gyroid infill and it's quite stiff. You can adjust the settings base on your liking.