Rockwell Jawhorse Replacement Jaw
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement pad for the urethane jaws of the Jawhorse that periodically crumble to dust.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 201
- Makes
- 3
- Views
- 1,669
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement for the urethane jaws that came with the Rockwell Jawhorse. Replacement jaws were extraordinarily expensive when they could be found. It was almost cheaper to buy a new Jawhorse.
This model is based on the following:
Rockwell Jawhorse Replacement Jaw (http://www.thingiverse.com/thing:3411940) by Zeru is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/
The model was regenerated in Fusion360 and the CAD file is provided. The model has been modified to be closer to the original vise jaws that came with the Jawhorse - there are nubs on the back of the pad which fit into the holes on the Jawhorse vise.
The model can be printed without supports face-down. There are thin layers inside the holes which must be cut or punched out. A material with some flexibility should be used to print the model - PLA and PETG are too hard. I used NinjaFlex TPU with infill and the pads are very soft.