OpenGarage Enclosure V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An enclosure for board version 1.4 of the garage door controller from opengarage.io
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 232
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This is a remix of a TinkerCad design created by user rayshobbyshop.
It is an enclosure for board version 1.4 of the garage door controller from opengarage.io. Other controller versions may also fit, but YMMV.
Features...
- Designed to fit the OpenGarage v1.4 board.
- Uses M3x10mm socket cap screws so the case can mount flat against a surface.
- Back plate mounting holes are enlarged to accommodate #8 screws.
- Additional case holes added for the reset button, and screw terminals.
- Hole for 90°header pins on GP4/GP5/GND for external door sensors.
With the header pins installed for an external door sensor, some additional finagling around the ultrasonic sensor holes may be needed to the get the board into the case.
If you print with a translucent filament, it's possible to see the status LED on the ESP component.
I have also made the remixed design available on TinkerCad as well.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
0.4 mm
Infill:
10%
Filament: Atomic Filament PLA Translucent Smoke Black PLA
Category: DIY