1 / 3
Tumbler Turner with Extensible Storage/Stand — image 1
1 / 3

Tumbler Turner with Extensible Storage/Stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Tumbler turner and storage parts that can be interlocked to expand indefinately. 300mm+ print bed required.

Rating
0 / 5
Likes
19
Downloads
93
Makes
0
Views
684
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

I designed this tumbler turner at the request of my partner.  However I wanted to do something a bit different than I have seen before.  I created an interlocking turner and integrated stand/storage that is indefinately extensible.

The turner uses a standard CW/CCW AC synchronous motor (I recommend 5-6 rpm).  I have included a basic model of my motor, though the motor shaft type can vary in the attachment method, so has been left ambiguous.  My example has a 3mm hole drilled through the side of the shaft.  Also note, these motors seem to get hot.  If printing with PLA, I would recommend thermal gluing a heatsink to the motor or printing with a more thermally stable resin, such as PETG.

The mid-support tower has a 22mmx7mm inset for a 608 sealed bearing or similar, however I included the model of a ring that can be inserted in place of a bearing if using a 20mm OD PVC pipe.  The PVC pipe I used has a 16mm ID that I have included the coupler file for which is fixed to the motor and coupler with a removable clip.  I have tried using a 7mm shaft and bearing, but I didn't like it as much.  However, I have an example photo of these possible builds.

There is a channel for wiring to a rocker switch that can be inserted into the front right of the base.  If using this kind of switch, I would highly recommend one with a cover. Panel cutout dimensions: 28.2mm x 11.5mm.

The storage and stand part can be slid onto the side of the turner base and locked in place using a rigid wire or, in my case, a medium paper clip straighted out.

 

Things you may need beyond the print:

  1. CW/CCW AC synchronous motor
  2. AC plug and cable
  3. Rocker switch, wiring and terminals (if your cable does not have a switch)
  4. Wire connectors
  5. PVC pipe (print ring) or 7mm shaft (608 bearing)
  6. Coupler.  You may need to fashion your own if your motor has a key or screw shaft.
  7. ~1.5mm x 180mm wire for each attachment point.

 

Notes:

  • I have a 400^3 mm print area, so I have not optimised this for breaking apart for smaller print beds.  There might be a creative way to do this, but I have not thought on it much.  I can look into it if there is demand for it.  No promises though.
  • I have a model of the motor 7mm shaft, to a 7mm rod collar.  However I never refined the tolerances and wobbled a lot in my testing.  The straight PVC pipe seemed a more elegant solution, but I can provide those extra files if there is interest.
  • I designed this with a .6mm nozzle in mind.
  • My PLA prints showed signs of glassing from the motor heat, but otherwise appeared to remain secure.  Mileage may vary.
  • For PLA, I would recommend extra perimeters or higher infil % around the support structure and screw holes, especially around the motor.

 

 

Tags