Makita 18V charger holder for pegboard
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Easy "on and off" Makita 18V battery charger mount.
- Rating
- 4.833 / 5
- Likes
- 106
- Downloads
- 721
- Makes
- 5
- Views
- 6,069
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Easy "on and off" Makita 18V battery charger mount. Sized to fit: pegboard (1 inch on center holes), Makita DC18RC or DC18RA -- leg (or "feet" on bottom of charger). Spacing may be different on other Makita charger models. Model DC18RC and DC18RA have feet 153mm on center. I used only the top two legs, replacing (and saving) the rubber feet from the top row. Use M3 x 10mm or 12mm length bolt with each "bolt" (see parts to print). The M3 bolt screws into the model bolt part and expands it a bit to secure inside the Makita charger leg. All can be printed without support, requiring minimal clean up of the hole for the M3 bolt. Two models -- "square" and "rounded"...just for fun. The square version may have a little more strength, but I've never tested that hypothesis. I use both.
Print instructions
I used PETG, no support needed (just a bit of clean up for bolt), 3 perimeters, 3 or so top/bottom, and 25% or more infill for strength.