USMC - EGA Tribal Phone Stand

To all my Devil Dogs!  Need to put you phone somewhere so you don't lose it?  When Field-day Inspection comes and wanna show off how Moto you are?  How about looking Moto-stylish at work?  Then print one of these in various colors, add stickers, or even paint on it!

**PRINTING RECOMMENDATIONS**

Print this lying on its side at full scale.  Fits mostly, iPhones and certain Android phones. Can be printed on an Ender 3 or equivalent.  See picture for print out.

Looks even better when using a resin printer.  See pictures for support setup and the time it takes to print on an SLA/LCD type printer that uses resin.

Best Printed with the below settings using Cura Slicer:

**NOTE:  Supports should be blocked everywhere, except for middle area where the phone would sit.

Print Quality:  Standard or Higher

Print Wall:  Layers - 3 or 4 and select “Optimize Wall Printing Order”.

Print Top/Bottom:  Top/Bottom Layers - 4.

Infill:  Density: 10-20%

Print Speed:  40 mm/s for the “Outer Wall” speed and everything else at 50-70 mm/s.

If using translucent filaments, I recommend using the setting below:

Print Quality:  Detailed or Higher

Print Wall:  Layers - 2 and select “Optimize Wall Print Order”

Infill:  0% 

Print Speed:  30 mm/s for the "Outer Wall" speed.  Everything else at 40 mm/s.