1 / 5
Omnifixo Pinecil Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My Omnifixo needed a cool field kit, but I dont own a TS80P, I own a Pinecil.
- Rating
- 4.889 / 5
- Likes
- 243
- Downloads
- 715
- Makes
- 11
- Views
- 11,849
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
My Omnifixo needed a cool field kit too, but I don't own a TS80P, I own a Pinecil. There's room for improvement, but I'm pleased with it. The plate is best slid on from the side so the magnetic clamp bases don't shoot out and stick to it. The plate is fully flush with the edge when in place on top. Stays on nice and tight, the lid doesn't come off even if turned upside down and shaken.
This was printed with a .6mm nozzle at .3 layer height, in PETG. The 3 magnets are 3mm(2.65~)x8mm.