Finger Door Pull, Small Round
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.25 – €0.31 net (excluding VAT)
For file: CE3_1v.38.1x35idRing.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.28 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 18 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Fairly simple to install into round hole made with a 1-1/2" spade or Forstner bit.
- Rating
- 0 / 5
- Likes
- 34
- Downloads
- 44
- Makes
- 0
- Views
- 588
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
This round finger flush knob is for cabinet and doors that can be opened/closed with your finger.
You can install it in panels greater than 13mm by drilling out a 1-½" diameter hole 12 mm deep. I was able to do that in a scrap 2 x 4. By drilling until the drill just starts to poke through the wood, it will locate the center. You can then use the drawing as a template to locate the hole center on the back of the frame and mark the 3 mm clearance holes for the 3 mm screws.
For any thickness wood frame you can force the 35 mm press fit cylinder onto the knob and press-fit the assembly into the 1-½" hole. Guaranteed with my reputation, it will not come out, if you use the 38.1 mm outside diameter ring. Other rings are also available that are a bit looser in the hole.
There is a small circular indentation on the front that shows where to push and where the center of gravity that closes the flap is located. Play with the axis to see how you want it to open and close.