Baseboards for where floor and wall meet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Includes inner curve and outer curve segments. Very scalable. Uses minimal material.
- Rating
- 5 / 5
- Likes
- 40
- Downloads
- 265
- Makes
- 0
- Views
- 2,224
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
I have produced this design by trying lots of ideas and printing a lot of imperfect baseboards for my bathrooms. By the time the model here was refined, the prints were coming across very reliably good.
I recommend priming and painting these, and using a silicone caulking agent to bind them to the wall and each other.
This design requires a printer that can bridge a halfway decent span of about 80mm. If yours doesn't, you can add very sparse (widely spaced) supports to help support the structure.
PS slicing settings should include at least 5 top layers and 3 bottom layers in the default orientation. I used a layer height of .22 but you could go finer if you want better detail on the curved part. Number of perimeters should be 3 or more. Gyroid infill of 10% should be plenty.
Obviously you'll scale the board to your printer, but only in one axis. Generally this is done by unlocking the x-y-z scaling and only adjusting the scale in the length plane.