stackable threaded container with lid - vase mode
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
a vase mode stackable threaded container for small stuff like screws, also a lid for the very top of the stack
- Rating
- 5 / 5
- Likes
- 45
- Downloads
- 296
- Makes
- 5
- Views
- 1,118
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This started as a proof of concept / modelling exercise and turned into something quite usable along the way.
Print one lid and one container (or a dozen, go wild!) and screw them onto each other!
All need to be done in vase mode / spiralized outer contour with a closed bottom and a single wall line only. Therefore, you need to place the lid with the thread pointing upwards and the container with the (slightly) larger thread pointing upwards.
I did some tinkering to get the measurements right for my printer (0.4 mm nozzle), and while I do hope that this works for you, nonetheless results may vary - please comment if you're facing difficulties, I should be able to add models with tighter or looser tolerances between male and female threads.
I just printed these today, so I'm not sure how durable they are - don't expect miracles, I guess. My focus here was definitely to reduce print time as best as I could - my machine took 37 min for the container and about 25 min for the lid.
Anyway, enjoy and tell me how they work for you - tips, improvements and constructive criticism greatly appreciated!