Wanhao i3 Plus LED Carriage for Print Bed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
We are bringing the Powerspec Wanhao Duplicator i3 Plus to a trade show and we wanted to add some bling to it so we…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 8
- Makes
- 0
- Views
- 192
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
We are bringing the Powerspec Wanhao Duplicator i3 Plus to a trade show and we wanted to add some bling to it so we designed a carriage to hold a LED strip. Very easy to print with minimal support and fits right in. You will need to use a printer that's bigger than the Wanhao because it's bigger than the print bed--we looked at a design that could be printed in parts, but it was not secure and the LED strip moved around too much.
As an added bonus, there's also raised rings added to secure the springs so they don't slide around and create X/Y errors.
We used a simple LED strip from Amazon: USB - Powered LED Light Kit
Print Settings
Printer:
Lulzbot Taz 6
Rafts:
No
Supports:
Yes
Post-Printing
LED Installation
1.) Remove all supports from printrn2.) Starting in the back left corner, insert the LED strip where the strip connects with the cable. (see image below)rn3.) Run cable through strain relief and hold in place while you press the LED strip into the channel that goes all the way around the print bed.rn4.) Trim excess LED from strip by cutting where the manufacturer indicates is safe to cutrn5.) Remove last 2 inches of sticky backing and secure into channel. You do not need to remove all of the sticky backing for the entire length if it's placed tightly in channel.
Part Installation
1.) Move Z axis all the way uprn2.) Turn off powerrn3.) Unscrew all 4 adjustments nuts and put springs in containerrn4.) Slide the print bed diagonally through the print and put into place. It should fit snug in all four cornersrn5.) Replace thumb knobs and tightenrn6.) Re-do print bed leveling
Category: 3D Printer Accessories