Gaugemaster / MRC Prodigy Express Holsters
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Summary A set of holsters/brackets for use with the Gaugemaster (MRC) Prodigy Express DCC controller and base station.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 70
- Makes
- 0
- Views
- 505
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Summary
A set of holsters/brackets for use with the Gaugemaster (MRC) Prodigy Express DCC controller and base station. The controller holder will also work with the Prodigy Advanced controller.
Notes:
The controller holster is one part. It has countersunk screw holes and should be printed upright with no supports necessary. PLA+ is a good material for this, as it has some flex but is easy to print.
There are two versions; one is a wee bit smaller length ways to save on plastic. The base station holder comes in two parts to make printing easier and cut down on supports; use solvent weld (e.g. EMA Plastic Weld) to make a permanent joint.
While my Creator Pro managed to print it fine without supports in the cut outs, some printers/settings may not bridge so well, so you may need to add supports there.
These holsters are designed to be a snug fit. You can always increase the print scale percentage by 1% or so if they're a little tight on your set up/printer calibration.
Print instructions
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
20% (or thereby)
Filament_brand:
Rigid Ink
Filament_material:
PLA+