Gaugemaster / MRC Prodigy Express Holsters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Summary A set of holsters/brackets for use with the Gaugemaster (MRC) Prodigy Express DCC controller and base station.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 505
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Summary
A set of holsters/brackets for use with the Gaugemaster (MRC) Prodigy Express DCC controller and base station. The controller holder will also work with the Prodigy Advanced controller.
Notes:
The controller holster is one part. It has countersunk screw holes and should be printed upright with no supports necessary. PLA+ is a good material for this, as it has some flex but is easy to print.
There are two versions; one is a wee bit smaller length ways to save on plastic. The base station holder comes in two parts to make printing easier and cut down on supports; use solvent weld (e.g. EMA Plastic Weld) to make a permanent joint.
While my Creator Pro managed to print it fine without supports in the cut outs, some printers/settings may not bridge so well, so you may need to add supports there.
These holsters are designed to be a snug fit. You can always increase the print scale percentage by 1% or so if they're a little tight on your set up/printer calibration.
Print instructions
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
20% (or thereby)
Filament_brand:
Rigid Ink
Filament_material:
PLA+