Fanatec Pedals Universal Playseat Challenge Mount - V3 & CSL Elite

Universal Playseat Challenge Fanatec Pedals Mounts

After breaking the existing pedal mounts I found on Thingiverse I decided to design my own that would both be more durable and more versatile. This universal mount allows you to affix both Fanatec V3 & CSL Elite pedals to the Playseat Challenge.

These mounts do not require you to remove the foam of the Playseat Challenge and they allow the CSL Elite pedals to be used in either the farthest apart position or 1 notch in.

A 10mm Wrench is required if you do not wish to remove the footplate on the V3 pedals or if you do not have a low-profile Allen key for the CSL Elites.

Installation:

    V3:

Install ZipTies in mounts

Install rear pedal mounts with M6 Bolt and washer

Option A:

Remove the footplate (3x Red bolts)

Install front mounts

Option B: (Requires 1mm Wrench)

Install front mounts with the bolt in the hex hole on the mount

Tighten ZipTies around Playseat Challenge by pulling down then pulling up

Trim ZipTies

    CSL Elite:

Install ZipTies in mounts

Install rear mounts

Install front mounts with the bolt in the hex hole on the mount

Tighten ZipTies around Playseat Challenge by pulling down then pulling up

Trim ZipTies

Requirements:

1x 5mm Allen Key

1x 10mm Wrench (Only for CSL Elite or V3 Option B)

8x ZipTies 5mm

4x M6x25mm Socket Head Bolt

4x M6 Washer

4x M6 Nyloc Nut

Print Settings

Printer Brand:

Creality

Printer:

CR10S PRO

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

15

Filament:3D Printz PLA Black