USB Cable Holder
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.89 – €2.31 net (excluding VAT)
For file: clamp-v3_0.2mm_20%_6p_1h38m_6.61778m_PolyLite White ASA.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.10 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 1.64 hr
- Source material
- ASA
- Estimate material
- ASA
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A screw clamp for a desk/table surface to hold 2 USB cables.
- Rating
- 5 / 5
- Likes
- 179
- Downloads
- 1,515
- Makes
- 13
- Views
- 4,790
- Reviews
- 14
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This design is meant to hang 2 USB cables at the edge of my desk top.
I originally designed this about 3 years ago. I decided to update it and make some changes for publishing. The original design was printed upright to allow clean screw threads and, therefore, required a lot of support. The new design is meant to be printed on its side and uses a lot less support. I avoided the support need around the screw hole by adding a small notch cutout for the stringy bridging at the top of a hole to happen without interfering with the screw.
I used ASA and 6 perimeters for strength. I also set the minimum threshold for solid infill to 1000mm - the result is effectively solid with no infill. This should also increase layer adhesion area in the screw shaft (as printing a screw upright puts the layers in the weakest position).
The dimensions of it are set for my tabletop overhang. While it might be desirable to have a deeper throat for a clamp, my tabletop overhang is only about 1 inch. My surface is also 1 inch thick, but the clamp has a range of about 15-30mm.