1 / 1
KFL08-2474x10 thrust bearing mount for Ender 3 and clone printers — image 1

KFL08-2474x10 thrust bearing mount for Ender 3 and clone printers

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This design exists to take the load off of the stepper motors so that the weight of the X-axis is always supported.

Rating
0 / 5
Likes
1
Downloads
17
Makes
0
Views
214
Reviews
0

Updated at source:

Model information

License
GNU General Public License v2.0

This design exists to take the load off of the stepper motors so that the weight of the X-axis is always supported.  It also acts as a 90° support for the Z-axis and will keep the lead screw parallel with the Z-axis if properly assembled and installed.

Without this part the weight of the x-axis is always pushing against the stepper motor and is trying to turn the Z-axis lead screw in the other direction.

I had issues with v14 colliding with the brackets attaching the x-axis to the Z-axis extrusions.

v16 Attempts to resolve this by removing the platform that the Pillow block (a.k.a. Thrust bearing) sat upon. I also took some bits off of the back side to reduce the odds of collision and make the whole thing a bit less chunky. 

Assembly: 

You need to put the screws for the rear mounting point in before inserting the motor. Attach them to their T-Nuts. Now you can assemble the rest in mostly any order.  For v14 it was critical to already have the worm screw coupler attached to the motor before inserting it but since the top is open on v15 and v16 that shouldn't be an issue.  Once the coupler is attached and the motor is mounted with M3 screws (2x20mm and 2x ~14mm) then you can attach the KFL08-2474x10 thrust bearing to the top, insert the worm screw and tighten the set screw on both the coupler and the thrust bearing.  Since this part has T-Nuts on both the bottom and rear it also doubles as a 90° Bracket for your printer.

Designed for my original Ender 3. Your mileage may vary when using this with later editions / version of the Ender 3 and / or Ender 3 clones.

V14 doesn't work because of the collision issue, but I've left it in the project to show where the thrust bearing mounts, since it isn't as obvious with the later versions.

Feel free to remix and adapt this design to your printer. 

I recommend printing using supports, and make sure they won't attach too firmly. Do not use an outer perimeter wall. I recommend using zigzag pattern with a decent amount of support interface distance.

BOM:

Here are some Amazon links to the parts I used for this project.  Using these links helps support my work developing and giving away these printer mods.

KFL08 Thrust Bearings:

https://amzn.to/3Rqir1P

T-Nuts:

https://amzn.to/3T9f1Sh

Assorted M3, M4, M5 Machine Screws:

https://amzn.to/3GLNLlH  ←This is the exact kit I used and designed for.

Other options: https://amzn.to/46H0L6j 

Threaded Brass Inserts:  

https://amzn.to/482lORU  ← 2 of these are needed for mounting the Thrust Bearing. 

Another Popular Brass Insert kit option:  https://amzn.to/3RqzlND 

My Ender 3 is dual Z, so part of where this is going is an eventual 3D printed kit to upgrade a stock Ender 3 to dual Z without needing to buy an expensive kit that doesn't always work very well.

 

Tags