Bosch Colt CNC Vacuum - Brush Remix

Remixed chschmit's brush boot part to accept M3 nuts, so it can be bolted to the router flange. Simply drill the router flange to pass M3 bolts for a non-glued quick release Colt vac attachment. Note that the 3 vertical parts inside the air path should be removed with pliers after printing. Those are there to provide support and are not required for operation. In fact if you do not remove them the may get clogged up with stringy wood chips (like Mahogony).

If you happen to have an MPCNC Primo J, you might be interested in using my remixed mount to go with this thing: https://www.thingiverse.com/thing:4632040

Update 12/3/2020:

I found glue to be inadequate for holding the plenum to the brush clamp. So I remixed it to make it a one piece part. The part is not changed dimensionally outside of the remeshing tolerances. In F360 I split the connecting flange of the plenum, scaled that up a tad along the Y to give a mating surface (to close up the clearance designed into the original part), re-centered the parts, did a mesh merge, a close mesh operation at high resolution (120MB), then a mesh reduction to reduce file size to the final 35mb (still portly). The added strength and reliability are well worth the bandwidth though. ;)

Print Settings

Rafts:

Doesn't Matter

Supports:

Category: Machine Tools