1 / 1
No Overhang Face Shield Bottom Reinforcement for Prusa Face Shield
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This remix fixes the overhang of the bottom reinforcement for Prusa face shield.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 106
- Makes
- 0
- Views
- 465
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial
This remix fixes the overhang of the bottom reinforcement for Prusa face shield. Allowing you to print them at faster speeds without worrying about overhangs! It uses the same amount of filament as before but much easier to print and offers a little bit better bed adhesion.
Print instructions
Any layer height would work as there are no more overhangs. Tested with 200% speed with the standard 0.3mm PETG setting in Prusa slicer and it works perfectly fine. Your experience may vary.