Phone Mount for Rivian
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ball mount for the Rivian R1T and R1S. No adhesives or drilling required.
- Rating
- 5 / 5
- Likes
- 57
- Downloads
- 629
- Makes
- 4
- Views
- 5,227
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
You can use any 15mm, 17mm or 1 inch ball attachment to add a phone/accessory mount or charging to your dash. It clips in the decorative channel between the screens with a little pressure.
This model is inspired by the mounting meathod created by RWerksman at https://www.thingiverse.com/thing:5427851
However, I designed this new model from scratch with a more secure fit in mind and a raised mounting point to avoid the steering wheel blocking the phone. It’s pretty solid considering how tall it is.
I recommend printing vertically with ASA (PETG will work, but can deform in a hot car) due to the flexibility needed when installing. Add a modifier to the top ball and ball arm to make it 100% infill in the top section so it doesn't warp when pressure/weight is added. I used 30% infill for the mid-section and 10% for the bottom section. Reference the GCODE files to view where I put infill modifiers or just use them for your prints! It sounds complicated, but I promise it's an easy print!
To install, push the base in until it snaps behind the center screen.
I personally am using a MagSafe charger attached to an adhesive female ball mount.