Tilt-arm for mounting accessories
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.29 – €0.36 net (excluding VAT)
For file: fastener_stand_02mm_petg_mk3s_24m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.33 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 23.4 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
I needed an adjustable and tilting arm for mounting different little accessories (e.g.
- Rating
- 5 / 5
- Likes
- 69
- Downloads
- 232
- Makes
- 0
- Views
- 2,237
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed an adjustable and tilting arm for mounting different little accessories (e.g. a pop-filter, little lights or a little microphone) to a stand. Therefore I made this arm with a indexed hinge and a ball joint.
The special thing is that you can create your own adapters for the accessories you need. Just make a octagon-hole (13m side to side) and a hole for a M3 screw in your adapter and you can mount it to the end of the arm. I included an example of an adapter which can rotate and tilt around 3-axes.
Both arms are 156mm long (from the mittle of the hinge to the end of the arm). The clamp is made for a bar with 15mm in diameter.
Print instructions
Print settings
Arm
layer-height: 0.2mm
perimeters: 4 (for greater strength)
material: PETG (for greater strength)
BallJointSocket
layer-height: 0.2mm
perimeters: 3
material: PETG (for greater strength and flexibility)
Ball, knob and fasteners
layer-height: 0.2mm
perimeters: 3 or 4
material: PETG (for greater strength)
Additional needed parts
3x M6x30 hex-head screw (you will have to shorten one for the knob)
3x M6 hex nut
min. 2x M3x30 countersunk head screw and 2x M3 nut for mounting the ball and the adapter
additional hardware, depending on your adapter
Assembly instructions
First, push the ball on one arm and secure it with a M3 screw and a corresponding nut in the dedicated slot. Now try to push the ball-end in its socket. You may have to locate the ball and the arm sideways before you cann push it in. Next, you can insert the M6 nuts in the knob and the fasteners and mount them with the M6 hex-head screws like in the pictures. You have to shorten the screw for the knob and also pay attention to put the correct fastener in the correct hole, otherwise you can't tighten them.