Case for Deskpi Super 6c
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple case for Deskpi Super6c pi cluster board
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 111
- Makes
- 0
- Views
- 796
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Public Domain
Simple 1U case for the DeskPi Super6c cluster board.
Easy print. No supports required. Prints in any material. I printed in PLA.
Requires 8 small M3 heat-set inserts. Make sure they are 4mm or less in total diameter.
Designed to hold 3 40x20mm case fans. Noctua NF-A4x20s fit snugly enough to just use friction if you don't want to install the screws.
I did an acrylic laser-cut top for mine to replace the 3d printed top included in the model. The .step file is included below - its dead simple to extract a DXF of the top to import into Lightburn or other laser cut tools.
Lots of mistakes here. This was my first project done in f360 and I still have a lot to learn!